![]() I created a living hinge as spine for my book.Change dpi and frequency to 300 this meant cleaner lines on spine that weren’t so burnt.At first I chose combined setting but the image didn’t cut out properly so I done colour mapping and experimented with different power and speed on small prices of wood.Laser started cutting lower down so I changed ‘Configure’ setting on laser cutter so it started at ‘0’.To ensure the measurements were accurate I first measured my panel of wood: However, I had to crop the template slightly to fit the bit of spare wood I had. I made sure to keep the settings exactly the same as recommended. I downloaded a living hinge template from the official website. ![]() If their line is 0.76 don’t change to 0.001 (Any lines are cut any fills are engraved)Įnsure that the measurements are set to that of the machine: 173 mm height/ 430mm width I chose to create a wooden book with a living hinge spine, however it took a few attempts as it included engraving and vector cutting:Ĭhange brush stroke to basic and 0001 thickness
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |